Logan, UT Furnace Repair Frequently Asked Questions
Direct answers to common homeowner questions about gas furnace symptoms, safety, pricing, and local Cache Valley dispatch.
Browse answers below, or jump directly to our emergency repair, gas furnace repair, or cost calculator pages. Return anytime to the Logan Furnace Repair home page.
First check that your thermostat fan is set to AUTO rather than ON. If it is on AUTO, the furnace may have tripped its high-limit safety switch from a dirty filter or entered an ignition lockout.
This is called short cycling and is most commonly caused by a clogged air filter, restricted vents, a dirty flame sensor, or an overheating heat exchanger.
In freezing Cache Valley weather, a properly sized furnace typically runs for 10 to 20 minutes per cycle. Runs of only 2 to 3 minutes indicate short cycling.
Clicking without ignition usually points to a cracked hot surface igniter, a faulty ignition control module, or a gas supply/valve issue.
Yes. A cracked heat exchanger can allow carbon monoxide to mix with indoor household air. If a technician confirms a crack, the furnace should be shut down immediately.
Most standard hot surface igniter replacements fall between $165 and $360 including parts and labor, depending on furnace brand and dispatch timing.
If your furnace is under 12 years old and needs a minor component like an igniter, sensor, or capacitor, repair makes sense. At 15–20+ years with a major failure, compare repair vs. replacement quotes.
Calling (435) 753-5175 connects you directly with an independent local heating contractor serving Logan and Cache Valley. There is no fee to call and no obligation to book.