Furnace igniter and pilot repair in Logan, UT restores reliable burner ignition by replacing cracked silicon nitride or carbide hot surface igniters, cleaning or replacing flame sensors, and servicing standing pilot thermocouples.
Signs Your Igniter or Flame Sensor Is Failing
- Burners Never Light: The draft inducer runs, you hear a relay click, but there is no orange glow inside the burner compartment.
- Ignites Then Shut Off in 3–5 Seconds: Burners light briefly and immediately extinguish—the classic symptom of a dirty or failing flame sensor.
- Standing Pilot Keeps Going Out: In older Downtown Logan or Wellsville furnaces, a weak thermocouple or drafty pilot assembly fails to hold the gas valve open.
- Furnace Locks Out After 3 Tries: Modern control boards lock out for safety after repeated failed ignition attempts, often leaving the blower running cold air.
Why Igniters Fail Mid-Winter in Cache Valley
Hot surface igniters experience extreme thermal shock every time your furnace cycles on during a freezing Logan night. Over 4 to 7 winters, hairline fractures develop in the ceramic element until resistance rises too high or the element breaks completely.
Because igniter and flame sensor replacements are straightforward for an experienced tech, they are among the most affordable gas furnace repairs. Explore estimated pricing in our repair cost calculator, or head back to our Logan Furnace Repair overview.
Frequently Asked Questions
Once the technician confirms the part on hand, replacing a standard hot surface igniter or cleaning a flame sensor usually takes 30 to 60 minutes including a full combustion test.
While some homeowners gently buff the metal rod with fine emery cloth after shutting off power, a recurring lockout can also point to grounding issues, gas pressure faults, or a failing control board.
Strong canyon winds near Hillcrest and East Bench can create downdrafts in older metal flues. A technician can check your chimney cap, draft hood, and thermocouple.