Skip to main content
24/7 Furnace Repair Referral Line — Serving Logan & Cache Valley, UT Dispatch Desk: (435) 753-5175
Cache Valley Furnace Repair Experts

Furnace Blowing Cold Air in Logan, UT

Nothing feels worse on a 15°F morning than cool air pouring out of your floor registers. Here is how local technicians diagnose and fix it.

Direct Answer

A furnace blowing cold air in Logan, UT is most often caused by a thermostat fan set to ON instead of AUTO, a tripped high-limit safety switch from a clogged filter, a failed igniter/flame sensor lockout, or leaky basement ductwork.

Top Reasons Your Furnace Blows Cold Air

  • Thermostat Fan Set to ON: The blower runs nonstop even between heating cycles, circulating unheated air through the ducts.
  • High-Limit Switch Tripped (Overheating): A dirty air filter or closed registers trap heat inside the furnace; the board kills the burners and runs the blower to cool the cabinet.
  • Ignition Lockout: After failed igniter or pilot attempts, many furnaces run the blower continuously as a safety indicator.
  • Blower Relay Stuck Closed: A welded relay on the control board keeps the blower motor running even without a call for heat.

Step-by-Step Local Troubleshooting

Before booking an emergency furnace repair call, verify your thermostat says HEAT + AUTO, replace a dusty 1-inch filter, and cycle the furnace power switch off for 60 seconds. If the air turns cold again after 3–5 minutes of running, stop resetting it and call (435) 753-5175.

For a deeper breakdown of all seven causes, read our full blog post: Why Is My Furnace Blowing Cold Air in Logan, UT? You can also check neighborhood notes for Hillcrest and Adams, or return to the Furnace Repair Logan homepage.

Frequently Asked Questions

Tap to Call 24/7: (435) 753-5175